Three features are necessary to install the Lock-n-Haul on your outboard motor.
1) Power outboard motor tilt
2) Accessible steering pivot rod flange bolt heads
3) Transom motor mount indents/concaves
(Additional fitup pictures available from main page)
*** May not fit (offshore) motors with 25"-30"shafts ***
See picture at bottom of this page and compare to your motor.
|
|
INSTALLATION MANUAL |
|
|
The Lock-n-Haul® is 13" long. The ends are 1" diameter and the tubes are 3/4" diameter. Tilt your motor until you have 13" between the steering pivot rod flange bolt heads, and the indents/concaves on the transom mounting bracket. If you can put a 3/4" diameter tube between them then it will work on your motor.
|
| Yamaha outboard features - Yamaha outboard features - Yamaha outboard features |
Power outboard motor tilt
| Accessible steering pivot rod flange bolt heads
| Transom motor mount indents/concaves
|
 |
| Click image for more detail. |
|
|
 |
| Click image for more detail. |
|
|
 |
| Click image for more detail. |
|
|
| Mercury outboard features - Mercury outboard features - Mercury outboard features |
Power outboard motor tilt
|
Accessible steering pivot rod flange bolt heads
|
Transom motor mount indents/concaves
|
 |
| Click image for more detail. |
|
|
 |
| Click image for more detail. |
|
|
 |
| Click image for more detail. |
|
|
| Evinrude outboard features - Evinrude outboard features - Evinrude outboard features |
Power outboard motor tilt
|
Accessible steering pivot rod flange bolt heads
|
Transom motor mount indents/concaves
|
 |
| Click image for more detail. |
|
|
 |
| Click image for more detail. |
|
|
 |
| Click image for more detail. |
|
|
| Why the Lock-n-Haul may not work on a 25"-30" shaft. |
|
